![hopw do i make sound forge 8 stop selecting sections hopw do i make sound forge 8 stop selecting sections](https://www.moviestudiozen.com/media/kunena/attachments/42/sound-forge-noise-reduction-4.png)
- #HOPW DO I MAKE SOUND FORGE 8 STOP SELECTING SECTIONS FULL#
- #HOPW DO I MAKE SOUND FORGE 8 STOP SELECTING SECTIONS WINDOWS#
This action closes the Record Remote window, and returns you to the full Sound Forge window. Click the Close button in the Record Remote window. When you are finished recording, click the Stop button. The Record button becomes a Stop button, and recording begins. When you're happy with the recording levels, and you're ready to record, click the red Record button in the Record Remote window. Never let the meter peak above 0.0 as this can 3Ĭause unpleasant distortion in the recorded audio.Ĩ. Try to keep the peak level around -3 with the average level around -6. The number at the right end of each meter represents the loudest audio peak for the signal being sent to that meter. Do not allow the meters to go into the red.
#HOPW DO I MAKE SOUND FORGE 8 STOP SELECTING SECTIONS WINDOWS#
Use the Windows Record Control to adjust the record levels (make sure you are adjusting the control that corresponds to the input device-in this case, adjust the Microphone control).
![hopw do i make sound forge 8 stop selecting sections hopw do i make sound forge 8 stop selecting sections](https://www.moviestudiozen.com/images/tutorials/2015/12/06/magic-strawberries-3.png)
Speak into the microphone and watch the input level as represented by the meters in the Record Remote window. This activates the Sound Forge record meters (the top meter represents the left channel in a stereo recording, and the bottom meter represents the right channel), and enables you to monitor the input level to achieve the optimal recording level. Make sure that the Monitor checkbox is selected in the Record Remote window. Click the Remote button in the Record window, and then position the Record Remote window so that you can see both the Record Remote window and the Windows Recording Control window as shown in Figure 4.ħ. Click the New button in the Record window to change the default settings.Ħ. In Sound Forge, choose Help, Contents and Index, Glossary to find definitions and explanations of these terms and settings. By default, Sound Forge creates a CD-quality file 44.1kHz for the sampling rate, and 16-bit 2įor the bit-depth. When preparing to encode for streaming audio, start with the highest-quality file possible. This opens a new data window and the Record window. Next run Sound Forge (Screenblast Sound Forge) and click on the Record button (the first button in the transport tool bar the one with the red dot on it). Figure 2 shows that we are ready to record using a microphone.Ĥ. Here, click the checkbox at the bottom of the control you want to use for recording, and set the input volume. Figure 1 shows the options you would select if you plan to record from a microphone and a tape deck (using the Line option).įigure 1 3. Select the source you will be recording from in the Show the following volume controls: list. Go to Options, and choose Properties, then select Recording and hit OK. The Windows Volume Control window will appear.Ģ. Double-click the speaker icon in the lower right corner of the screen.
![hopw do i make sound forge 8 stop selecting sections hopw do i make sound forge 8 stop selecting sections](https://usermanual.wiki/adobe/robohelp2015ugen.1891727298-User-Guide-Page-1.png)
Recording and Optimizing Audio in Sound Forgeġ.